MANIFOLD RISER 2"

The Figure 513 (13) Riser Manifolds
described in this technical data sheet
provide the necessary waterflow
alarm; pressure gauge; alarm test orifice;
drain; and sight glass equipment
in a single assembly for use in NFPA
13 sprinkler systems as follows:
NFPA 13*
? 1-1/2 Inch (DN40)
Male Thread x Female Thread
? 1-1/2 thru 6 Inch (DN40 thru DN150)
Groove x Groove
*Although the Riser Manifold described in
this data sheet is intended for NFPA 13
sprinkler systems; it may be used for NFPA
13D or 13R residential sprinkler systems;
where a test orifice of 5.6K (80K) is acceptable.
The variety of sizes and grooved end
connections allow cost effective and
easy transition to check valves; control
valves; and system piping. The Riser
Manifoldsmay be installed in either the
horizontal (flow switch on top) or vertical
(flow going up) for both single
sprinkler rises and floor control in high
rises.

Technical
Data
Approvals
The Figure 513 (13) Riser Manifolds
with a cover tamper switch for the waterflow
alarm switch are UL Listed;
ULC Listed; and FM Approved.
The Figure 513 (13) Riser Manifolds
without a cover tamper switch for the
waterflow alarm switch are UL Listed
and FM Approved.
Maximum Working Pressure
175 psi (12;1 bar)
Test Orifice
5.6K (80K)
Assembly
The manifold body of the Figure 513 is
ductile iron; whereas the manifold
body of the Figure 13 is cast iron. The
two assemblies are completely interchangeable
in function; application;
and end-to-end laying length.
Finish
Red painted.

See PDF for more details